Thickness gauge
Dial gauge is used by fitted to jig etc., while thickness gauge is held with our hand and work is held between gauge head and anvil, and its figure is directly read.
Gauge head moves to up when up-down lever is pressed down, and gauge head returns to g zeroh when it is released. As operation is easy, it is measured for a short period compared with micro-meter. There are 2 kinds of scale mark ,0.01mm, 0.001mm for both of analogue and digital. Stroke is available up to 50m as maximum thickness which depend on size of work. This can be used for various usages such as paper, rubber, plate, steel pipe, small molded products.
Steel work thickness is being measured, the photo shows 5.98 mm.
